Start-Up; Operation - Aura Allure Handbuch

Spray Tanning System Spray Tanning System Spray Tanning System

9. Start-up

Before connecting to the mains supply, be
sure that the supply voltage is identical with
the value given on the rating plate.
1. Unscrew the container from the spray
gun.
2. Prepare spray tanning lotion according
to manufacturer's instructions and pour
into the container.
3. Screw the container tightly onto the
spray gun.
4. Mount the air hose (Fig. 2, a + b).
5. Place the turbine only on a horizontal
level clean surface, otherwise the gun
may suck in dust, etc.

10. Operation

How the Spray Tanning system is handled,
including preparation of the work place
and spray tanning lotion as well as the
final result, is the sole responsibility of
the operator.
Wagner excludes any liability for damage
which may arise from overspray, applica-
tion errors, touch-ups, or non-compliance
with the instructions provided here.
•
Turn ON/OFF dial to 1 on the device
(Fig. 3).
•
Turn the material control (Fig. 4, 1) in
order to adjust the desired delivery rate.
lower material volume (-):
 turn anticlockwise
higher material volume (+):
 turn clockwise
•
Turn the air cap (Fig. 5, 1) with the union
nut slightly unscrewed (Fig. 5, 2) to adjust
the shape of the spray jet:
Fig. 6a vertical flat jet:
For spray movements from side to side
Fig. 6b horizontal flat jet:
For spray movements from top to
bottom
•
Pull the trigger to spray the tanning
lotion.
3
4
5
6
EN GB
1
2
1
a
b
7