Correction Of Malfunctions - Aura Allure Handbuch

GB EN

17. Correction of Malfunctions

Malfunction
No spray tanning
lotion comes out of
the nozzle
Spray tanning
lotion drips out of
the nozzle
Atomisation too
coarse
Uneven spray
pattern
Excessive overspray
Spray tanning
lotion runs down
body
12
Cause
•
Nozzle clogged
•
Material volume setting
turned too far to the left (-)
•
No pressure build-up in
container
•
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Spray tanning lotion has
accumulated on the air cap,
nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Material volume adjusting
screw turned too far to the
right (+)
•
Nozzle contaminated
•
Too little pressure build-up in
container
•
Air filter heavily soiled
•
Spray tanning lotion in the
container is running out
•
Nozzle seal worn
•
Air filter heavily soiled
•
Distance too large
•
Material volume adjusting
screw turned too far to the
right (+)
•
Too much spray tanning
lotion applied
•
Spray paths overlap too much
•
Spraying distance too small or
spray movement too slow
Spray Tanning System Spray Tanning System Spray Tanning System
Remedy
➞ Clean
➞ Turn material volume
adjusting screw to the
right (+)
➞ Tighten container
➞ Refill
➞ Insert
➞ Clean
➞ Clean
➞ Union nut tighten
➞ Change
➞ Change
➞ Turn material volume
adjusting screw to the left
(-)
➞ Clean
➞ Tighten container
➞ Replace
➞ Refill
➞ Replace
➞ Replace
➞ Reduce distance
➞ Turn material volume
adjusting screw to the left
(-)
➞ Carefully dab affected
points with a towel,
reduce flow setting if
required and lightly
overspray again