Maintenance; Storage - Aura Allure Handbuch

GB EN
Assembly
1) Slide the nozzle seal (Fig. 10, 1) with the
groove (slot) facing forwards into the
nozzle (2).
2) Put the nozzle onto the gun body and find
the correct position by turning it.
3) Put the air cap onto the nozzle and tighten
it using the union nut.
4) Place the container seal (Fig. 11, 1) from
below on the feed tube (Fig. 11, 2) and
slide it over the collar, while turning the
container seal slightly.
5) Insert the feed tube with container seal
in the gun body.

14. Maintenance

Important! NEVER operate the system
without the air filter fitted;
otherwise dirt could be sucked
in and interfere with the
function of the system.
1) Wash the air filter if it is soiled
(check daily in the case of intensive/
commercial use and replace if heavily
soiled).
2) For this pull the air filter out of the unit
(Fig. 12).
3) Insert a clean air filter.

15. Storage

Store unit away in a safe place with supply
cord wrapped around unit without any
twisting.
10
Spray Tanning System Spray Tanning System Spray Tanning System
10
11
12
1
2
2
1