Replacing The Lamp - AEG EJ2801AOX2 Benutzerinformation

26 www.electrolux.com
Problem
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easily. You attempted to re-open
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
the door immediately after
closing.

7.2 Replacing the lamp

Solution
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Make sure that there is
cold air circulation in the
appliance.
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
The appliance is equipped
with a longlife LED interior
light.