Cleaning The Control Panel; Trouble Shooter And Service - AEG LAVATHERM 72270AC Benutzerinformation

9.5 Cleaning the control panel

and housing
Use a standard neutral soap detergent
to clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.

10. TROUBLE SHOOTER AND SERVICE

10.1 Troubleshooting
Problem
The tumble
dryer does
not operate.
Unsatisfac-
tory drying
results.
The door
does not
close.
1)
Possible cause
The tumble dryer is not con-
nected to mains supply.
The loading door is opened.
The On/Off button was not
pushed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus function was in
minimum mode.
The condenser is clogged.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the inner surface of the
drum.
Too high water hardness.
The filter not locked in the po-
sition.
The laundry is locked between
the door and the seal.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents which
can cause corrosion to clean the
appliance.
Remedy
Connect in at mains socket.
Check fuse in fuse box (domes-
tic installation).
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Do the selection of the applica-
2)
ble programme.
3)
Clean the filter.
Change the Dry Plus function
to the moderate or maximum
mode.
Clean the condenser.
Obey the maximum load vol-
ume.
Clean the airflow grill in the
bottom of the appliance.
Clean the inner surface of the
drum.
Set applicable water hard-
4)
ness .
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
ENGLISH
75
3)