RED CASTLE SPORT Shop'n Jogg Disc II Gebrauchsanweisung Seite 56

If ...
The wheel
turns slowly
GB
The disc brake
does not slow
down the
wheel
properly
The brake
lever on the
handlebar is
stiff
55
ADJUSTMENTS TO THE FRONT WHEEL DISC BRAKE
Possible causes
The wheel is not in
the axle
The wheel axle is
too tight
The disc rubs
against the brake
pad(s)
The spring on the
brake cable is too
tight
One or both brake
pads are slightly
worn
The pad is
completely worn
The brake cable is
too tight
Suggested solutions
Check that the wheel axle is placed well into the
fork. If it is not, adjust the axle then lightly
retighten the nut.
Loosen the nut on the axle until the wheel turns
without difficulty.
PLEASE NOTE: There should be resistance when
you lower the quick release lever otherwise you
may lose the nut on the axle during use.
On the pad near the fork - tighten or loosen the
red washer (8a) to adjust the brake and to leave
only a minimum amount of space between this
pad and the disc.
Using the Allen key provided with the axle, loosen
the bolt on the cable by lightly unscrewing the
bolt situated just below the bolt (12), then
retighten.
PLEASE NOTE: The cable must always be taut.
On the pad near to the fork: Unscrew the red
washer (8a) to move the pad forward, leaving only
a minimum amount of space between this pad and
the disc. On the pad located near the front wheel
spokes: Use the Allen key provided with the axle
to lightly unscrew the pad (8b), bringing it nearer
to the disc.
Contact your stockist to order a new set of brake
pads.
Untighten the nut which is next to the brake
lever (11).