Panasonic EY4640 Bedienungsanleitung Seite 13

6) Use extra caution when making a
"pocket cut" into existing walls or
other blind areas. The protruding
wheel may cut gas or water pipes,
electrical wiring or objects that can
cause kickback.
Symbol
V
n
Revolutions or reci-
-1
...min
procations per minutes
Electrical capacity of
Ah
To reduce the risk of
injury, user must read
and understand in-
struction manual.
For indoor use only.
Always wear eye pro-
WARNING:
•
Do not use other than the Panasonic
battery packs that are designed for
use with this rechargeable tool.
•
Panasonic is not responsible for any
damage or accident caused by the
use of the recycled battery pack and
the counterfeit battery pack.
•
Do not dispose of the battery pack in
a fire, or expose it to excessive heat.
•
Do not drive the likes of nails into the
battery pack, subject it to shocks,
dismantle it, or attempt to modify it.
•
Do not allow metal objects to touch
the battery pack terminals.
• Do not carry or store the battery pack
in the same container as nails or
similar metal objects.
Meaning
Volts
Direct current
Rated speed
III. ASSEMBLY
battery pack
tection
- 13 -
• Do not charge the battery pack in a
high-temperature location, such as
next to a fire or in direct sunlight.
Otherwise, the battery may overheat,
catch fire, or explode.
• Never use other than the dedicated
charger to charge the battery pack.
Otherwise, the battery may leak,
overheat, or explode.
• After removing the battery pack from
the tool or the charger, always reat-
tach the pack cover. Otherwise, the
battery contacts could be shorted,
leading to a risk of fire.
• When the Battery Pack Has Deterio-
rated, Replace It with a New One.
Continued use of a damaged battery
pack may result in heat generation,
ignition or battery rupture.
NOTE:
When attaching or removing a slide
handle, disconnect battery pack from
tool.
CAUTION:
• Always be sure that the side handle
is installed securely before operation.
Screw the side handle securely as
shown in the figure.
CAUTION:
• Never actuate the lock pin when the
spindle is rotating. The tool may be
damaged.
Press the lock button to prevent spindle
rotation when installing or removing
parts, such as grinding disc, disc guard,
etc.