BioChef Astro Bedienungsanleitung Seite 7

VACUUM BLEND MODE
1. Plug cord into power socket. Lights will show on front of unit and the unit
will beep. Press the ON/OFF button to turn on.
2. Press the Vacuum Blend button and then the ON/OFF button again to start
the Vacuum Blend mode. The Vacuum Blend mode will begin by removing
the air from the jug and will then blend at varying speeds until programme
is finished.
3. The blender will continue to beep until ON/OFF button is pressed.
4. When you have finished blending, turn blender unit off at power socket.
5. Unlock and open lid of main blender housing. Remove blender jug. Before
opening the jug lid, lift the valve to release the vacuum pressure. Remove
jug lid and pour to enjoy.
6. To vacuum preserve the remainder of blender jug contents, transfer into the
vacuum storage container and use Vacuum (Only) mode - see below.
VACUUM MODE
1. Fill vacuum storage container with ingredients and attach lid.
2. Place vacuum storage container into main blender unit and close lid.
3. Press the ON/OFF button to turn on. Press Vacuum button and press ON/
OFF button again to start the Vacuum mode.
4. Programme will end when air has been optimally removed from vacuum
storage container.
Use the vacuum storage container to preserve sauces, raw fruits and
vegetables and many more ingredients.
MANUAL SPEED / PULSE / CLEAN MODE
Fill jug with ingredients and place into main unit. Press ON/OFF button to turn on.
MANUAL SPEED
Press the + or - to select the speed from 1 to 9. Press ON/OFF button. Blender
will operate at selected speed until ON/OFF button is pressed again to stop.
To prevent overheating, do not allow the blender to run for more than two
minutes at a time.
PULSE
Press and hold the Pulse/Clean button in bursts until you have blended to
the desired consistency. Pulse mode will always operate at maximum speed
setting.
EN
7