The Door; Wall Installation; Connection - WINEMASTER Wine C50S Bedienungsanleitung

Winemaster C50S(SR) USER MANUAL

6.6. THE DOOR

An adequately insulated door can be obtained in one of two ways:

Insulate an existing door with the same insulating materials used for the walls of the cellar. Provide a tight seal be-
tween the door frame and all sides of the door with a strip of foam rubber, for example.

Use a specially designed FONDIS Isothermic door containing polyurethane. In this case you are assured to have
a tight seal on all sides of the door which is equipped with a magnetic joint.
7. WINEMASTER WALL INSTALLATION
- Install the wooden frame into the wall.
The space between the wood frame and the insulation must be filled and sealed (with polyurethane for example), in
order to ensure a complete insulation.
Please note: exterior of the wooden frame must be even with the warm side of the wall or slightly past the wall so that
the WINEMASTER does not come in contact with the wall see diagram below:
Center the WINEMASTER correctly in its frame. Contact between the sheet metal and the wood frame could cause vi-
brations which could spread throughout the cellar.
- Secure the WINEMASTER with the 3 wood screws and washers.

8. CONNECTION

-Insert the plug into the socket
19
03/2009