Tightening The Bar Nut - Husqvarna K970 II Chain Bedienungsanweisung

• Remove the "halfmoons", the cup guard, o-ring and
the drive sprocket.
• Assemble the parts in the reverse order.
IMPORTANT! During all reassembling, make sure that
the outer cover fits in to the inner cover, the covers may
be damaged otherwise.
Make sure that the chain adjuster pin fits into the hole on
the bar.

Tightening the bar nut

If the bar and chain tensioner handle feel loose, the bar
nut must be tightened to achieve the correct tension
moment in the nut. This so that the bar does not fit loosely.
• Move the lever to its rear, lower position. Push in the
spring on the chain tensioner handle and turn the bar
nut clockwise by hand.
• Release the spring. Hold the bar upwards as you
move the handle forward. Note that the arm's
mechanical stop shall not be reached. The stop
ASSEMBLING AND ADJUSTMENTS
prevents the arm from pointing forwards and prevents
cutting.
–
English 11