Connect A Power Source - Husqvarna PP 325 E Bedienungsanweisung

ASSEMBLING AND ADJUSTMENTS

Connect a power source

IMPORTANT! Check that the mains voltage corresponds
with that stated on the rating plate on the machine.
• Connect the incoming power cable. The cable must have
three phases and grounding. Neutral should also be
available as the single phase sockets on the distribution
box will not work otherwise. (Only on 5-pin machines)
• The single phase sockets are protected with a 16 A
residual current circuit breaker with overcurrent protection
(C type). Following the connection on incoming current,
the single phase sockets can be used for e.g. a drilling
machine, water suction apparatus, etc.
– 9
English