Setting Up The Parent Unit; Inserting Batteries - Lindam clarity LD166 Bedienungsanleitung

Digital audio monitor

Inhaltsverzeichnis

Verfügbare Sprachen

SETTING UP THE PARENT UNIT

Your Parent Unit should be fitted with the 2 Rechargeable AAA Batteries supplied. The Unit can then be charged by placing it in

the Charging Dock. It may also be powered continuously by mains electricity by simply keeping it in the Charging Dock.

Warning! Ensure the rechargeable AAA batteries are in the Parent Unit at all times, even when using mains power. If the mains

power is lost the Unit will continue to work using battery power.

1. Rotate the Belt Clip 90º and remove. Slide down the Battery Cover. Insert the 2 AAA Rechargeable Batteries supplied

ensuring correct polarity and replace the cover.

2. Sit the Parent Unit into it's Recharging Dock.

3. Plug the Mains Adapter into the Charging Dock's Adapter Socket.

4. Plug the Adapter into your mains socket and switch on the power. The Power Light will illuminate on the Charging Dock.

5. Look at the colour of the Power / Charging LED on the parent unit. Whilst the unit is switched off you will see that the

Power / Charging LED will flash Amber showing that the unit is charging. When the batteries are fully charged the Amber

Charging light will switch off.

6. You can use your monitor immediately as long as your Unit remains in the Charging Dock for its initial charge

(10-12 hours). To switch ON press and hold the ON/OFF button for 3 seconds.

7. Look at the colour of the Power / Charging LED on the Parent Unit. When the batteries are charging and the unit is ON the

power LED will flash green and Amber, and will stay green when fully charged. When battery power is running low

the power light will flash green and you'll hear an intermittent "beep beep", please place the unit on the charging base

immediately.

Refer to the LED REFERENCE TABLE for a quick guide to the different LED settings.

IMPORTANT: The batteries require a continuous initial charge of 10-12 hours, subsequent charges should take 6 hours. Fully

charged batteries should last 8-10 hours.

Warning! Using an incorrect adapter may permanently damage the charger and invalidates your warranty.

Inhaltsverzeichnis