Setting Up The Parent Unit - Lindam clarity LD167 Bedienungsanleitung

SETTING UP THE PARENT UNIT

The monitor uses 3.7V 1000mAH Li-ion battery and the Mains Adaptor supplied
1. Slide down the Battery Compartment Cover at the rear of the Parent Unit.
2. Slot the battery in place from below ensuring the correct polarity.
3. Slide the Battery Compartment Cover back into place until it clicks.
4. Plug your Mains Power Adaptor into your mains socket and plug the other end into the Socket on your Parent Unit.
5. Roll the Thumb Wheel upwards. When it clicks power is On. Continue to roll it upwards to increase the Volume.
WARNING! Only use the Adaptors labelled OUTPUT: 6V DC that were supplied with your monitor. The use of other power
supplies is not approved and may damage your product and will invalidate your warranty.
CHARGING
Please charge the battery for 5 hours the first time it is used to ensure it's fully charged. Thereafter a full charge should take 4
hours. Once fully charged the battery will last approximately 6 hours.
The Li-ion rechargeable battery technology is similar to that used in today's mobile phones.
If the unit is switched Off when charging, the power light glows blue and will turn off when fully charged (no lights).
If the unit is switched On and charging, the power light glows blue and red. When fully charged the light will glow red only.
When the power is low the red light will flash as a warning.
7