Setting Up The Baby Unit; Mains Operation; Battery Operation - Lindam clarity LD166 Bedienungsanleitung

SETTING UP THE BABY UNIT

You can power your Baby Unit using either the Mains Power Adapter supplied or 4 x AA Standard Alkaline Batteries
(not supplied).

MAINS OPERATION

1. Plug the power cable into Power Adapter Socket of your Baby Unit.
2. Plug the Adapter into the mains socket and switch on the Baby Unit using the
ON/OFF button.
3. The green power Indicator LED should light.
4. Position the Baby Unit in a suitable position more than 1m from the cot
Warning! Only use the Power Adapters supplied with your product. Using an incorrect
adapter may permanently damage the Baby Unit and will invalidate your warranty.

BATTERY OPERATION

If you do not have suitable access to a mains socket in your baby's nursery you may wish to use batteries to power your Baby
Unit. Lindam recommend that you use a well known brand to ensure the best operating performance.
Good quality batteries (AA 1800mAh) will last up to 15 hours with the night light off, and 8-10 hours with the night light on.
1. Using a coin turn the Battery Lock anti clockwise and remove the Battery Cover
2. Insert 4 x AA Standard Alkaline Batteries (not supplied) ensuring correct polarity (indicated inside the Battery Compartment).
3. Replace the Battery Cover and turn the Battery Lock clockwise to secure.
4. When battery power is running low the Power Indicator LED on the Baby Unit flashes.
NOTE: The Baby Unit will only operate from batteries if the mains power is disconnected. You may use mains power when
batteries are inserted, but it is good practice to remove them if you intend to use mains power for a prolonged period.
Please switch off the Baby Unit before removing the mains power or the batteries.
4