Options - AEG LAVAMAT 75460TL1 Benutzerinformation

12 www.aeg.com
The information given in the chart above is compliant with the EU Commission regulation
1015/2010 implementing directive 2009/125/EC

7. OPTIONS

7.1 Temperature
Set this option to change the default
temperature.
Indicator
The display shows the set temperature.
7.2 Spin
With this option you can decrease the
default spin speed.
The display shows the indicator of the set
speed.
Additional spin options:
No Spin
• Set this option to remove all spin
phases.
• Set it for very delicate fabrics.
• To compensate for the absence of
spinning, the rinse phase uses more
water for some washing programmes.
• The display shows the indicator
.
Rinse Hold
• Set this option to reduce creasing.
• The washing programme ends with
water in the drum. The drum turns
regularly to reduce creasing.
• The lid stays locked. You must drain
the water to unlock the lid.
• The display shows the indicator
To drain the water refer to
"Draining water out after
end of cycle".
7.3 Stain
Set this option to add the stain phase to
a programme.
Use this option for laundry with hard
stains to remove.
Off Mode (W)
0.30
= cold water.
Left On Mode (W)
When you set this option, put the stain
remover into compartment
This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
7.4 Liquid Detergent
Press this button to adapt the cycle if you
use a liquid detergent.
The related indicator comes on.
7.5 Extra Rinse
With this option you can add some rinses
to some washing programmes, refer to
"Programme chart".
Use this option for persons allergic to
detergents and in areas where the water
is soft.
The related indicator comes on.
7.6 Time Save
With this option you can decrease the
programme duration.
• Press this button one time to set
'Shortened duration' for items with
daily soil.
• Press this button two times to set
.
'Extra Quick' for slightly soiled items
only.
Some programmes accept
only one of the two options.
7.7 Delay Start
With this option you can delay the start
of a programme from 30 minutes to 20
hours.
0.30
.