Replacing The Lamp; Closing The Door - AEG SDB41611AS Benutzerhandbuch

Problem
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

7.2 Replacing the lamp

The appliance is equipped
with a longlife LED interior
light.
CAUTION!
Disconnect the plug from
the mains socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).
Possible cause
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
There is no cold air circula-
tion in the appliance.
3. Replace the used lamp with a new
lamp of the same power and shape,
specifically designed for household
appliances. The maximum power is
shown on the lamp cover.
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
socket.
7. Open the door.
Make sure that the light comes on.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
27