Information For Your Safety; How To Use - LG V-CD6*4S series Handbuch

E

Information for your safety

Please read all the following information,
which contains important instructions for
the safety, use and the maintenance of the
appliance.
This appliance complies with the following EC
Directives: -73/23/EEC, 93/68/EEC-Low
Voltage Directive-89/336EEC -EMC Directive.
Never allow children to use the appliance
unsupervised.
Do not use the appliance If the supply cord
is damaged or faulty.
If the main lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent in order to avoid a hazard.
Always switch the vacuum cleaner off
before :
• changing the dust bag.
• changing or cleaning the filters.
If no dustbag is inserted, the cover
cannot be closed. Please do not use
force!
Do not vacuum flammable or explosive
substances(liquids or gases).
Do not vacuum hot ash, embers etc. nor
sharp objects.
Do not vacuum water or other liquids.
When you vacuum with an attachment
appliance that has a rotating brush roller,
do not reach into the running brush roller.

How to Use

Connecting the flexible hose
Push the end of the head (1) on the flexible
hose (2) into the attachment point on the
vacuum cleaner.
To remove the flexible hose from the vacuum
cleaner, press on the button (3) situated on the
head, then pull upwards.
Assembling the tubes
(depending on model)
• Plastic or metal tube (4).
- Fit together the two tubes by twisting slightly.
• Telescopic tube (5)
- Push spring latch (6) forward.
- Pull out tube to required length.
- Release spring latch to lock.
• Elbow tube (29)
The elbow tube is for uses such as cleaning
under the sofa, table and bed easily.
- Fit the elbow tube onto the end of the telescopic
tube and the grip handle.
- If you pull the latch (30), the elbow tube can
be bent.
- If you stretch the elbow tube, it is returned to
its position.
Using the cleaning head and Accessory
Nozzles (depending on model)
Fit the large cleaning head onto the end of
the tube.
• The 2- position head (7) is equipped with a
pedal (8) which allows you to alter its position
according to the type of floor to be cleaned.
Hard floor position (tiles, parquet floors...).
Press on the pedal to lower the brush.
• Carpet or rug position. Press on the pedal
to lift the brush up.
• Hard Floor Nozzle (31)
Efficient cleaning of hard floors (wood,
linoleum,etc.)
• Turbine brush nozzle (32)
- Air adjustment (33)
Slide the air control lever to the right
for long pile carpet and to the left for
short pile carpet.
- Cleaning turbine brush nozzle (34)
Press the button on the rear side of the
nozzle to separate the air cover.
Use the dusting brush & crevice tool to
vacuum clean the brush and fan.
•
Crevice Tool (9)
For vacuuming in those normally inaccessible
places i.e. reaching cobwebs, or down the
side of a sofa!
• Dusting brush (10)
For vacuuming picture frames, furniture
outlines, books and other uneven objects.
• Upholstery Nozzle (11)
For vacuuming uphostery,mattresses,etc.
The thread collectors help to pick up the
threads and fluff.
How to plug in and use
Pull out the supply cord to the desired length
and plug into the socket.
Press button (13) to start the vacuum cleaner.
To stop it press the button (13) again.
Adjusting the power level
•
(depending on model)
The flexible hose handle (14) has a manual
air flow regulator (15) which allows you to
• briefly reduce the suction level.
Electronic power control (16)
Suction capacity increases smoothly up to
MAX.
- 4 -