G21 VitalStick Bedienungsanleitung Seite 4

liquid.
13. This appliance should not be used by children and care should be taken when used near
children.
14. Avoid contacting moving parts.
15. Do not let cord contact hot surface, including the stove.
16. Do not blend hot liquids.
17. Neither the measuring beaker, nor the chopping bowl is microwave proof.
18. Use 3 cycles for mixing the food. Maximum mixing time is 1 minute for harder food (soft food
less than 1 minute). Than let the appliance to cool down for 2 minutes. If it is needed, mix the food
for 1 minute again.
19. To reduce the risk of injury, never place cutting blade on base without first putting bowl properly
in place.
20. Be certain cover is securely locked in place before operating appliance.
21. Clean the hand blender with dry cloth.
22. It shall warn of potential injury from misuse. Care shall be taken when handling the sharp cutting
blades, emptying the bowl and during cleaning.
23. Switch off the appliance and disconnected from supply before changing accessories or
approaching parts which move in use.
24. This appliance is not intended for use by children or other persons without assistance or
supervision if their physical, sensory or mental capabilities prevent them from using it safely.
How to use your blender & go attachment
1. Fill the frozen stick with water and storage in refrigerator in advance. Screw the frozen stick to
the bottle lid, to keep smoothies cooler for longer.
2. Place the blender bottle on a flat surface, with the open end facing up.
3. Cut the food to 15*15mm size, put them in the bottle, liquid first, then any solids.
4. Fasten the blade assembly on to the open end of the blender bottle and turn it in a clockwise
direction until it is end, when the inverted triangle alignment the round mark on the bottle, then
it's end.
5. Turn the switch to lock side to lock, it's a safety lock.
6. Place the motor unit on the bottle assembly until it locks.
7. Turn the blender and bottle upside down, press switch to operate the attachment. During
processing, hold the motor unit with on hand.
8. Once the blades have stopped rotating, unplug then put the bottle on a flat surface, press
release button to remove the motor unit.
9. Unlock the switch, replace the blade assembly with the drink bottle lid.
Note: Be sure not to fill ingredients past the 600ml marking of the personal blending bottle.
CAUTION:
Do not blend hot/warm ingredients-always allow to cool to room temperature before blending.