Team MC 1 Bedienungsanleitung Seite 9

Fax +32 2 359 95 50

MOUNTING AND USE OF THE MINI-CHOPPER (SEE PAGE 4)
Attention: for your own safety and a good functioning it is absolutely necessary to respect the
mounting described hereunder.
 Place the rubber ring on a flat surface, then insert the container in the ring (1).
 Mount the desired accessory (blade or mixer fitting) on the guide (2a or 2b). Therefore you
only have to push the axle of the guide in the hole of the desired accessory until it clicks.
To remove the guide, proceed inversely. By this handling pay attention not to cut yourself
and not to lose the guide, as it is useful for both accessories.
 Then place the all in the container paying attention that the guide is correctly placed in
the hole at the bottom of the container (3).
 Place ingredients in the container.
 Place the lid on the container respecting the positioning of its openings-out (4). If
necessary, turn the lid until it is correctly placed on the container.
 Place the unplugged motor block on the container (5) respecting the positioning of the
openings-out. If the motor block is not mounted correctly, it will be impossible to start the
appliance.
 Plug in.
 To start press the motor block with your hand holding the container with the other hand.
 To remove food, unplug and proceed the other way round, but pay attention not to hurt
you, as the blade is very sharp.
 Caution: do not put the bowl in the dishwasher and do not pour too hot liquids in it. Never
put the bowl in the microwave oven.
USE ADVICES
 Your appliance is not intended to work for long periods. So if your preparation requires
more than 1 minute continuously, it is absolutely necessary to follow breaks. The breaks
should last at least 2 minutes to allow the motor cool down.
 We advise you to chop the food by fits and starts and if necessary to mix them with a
spatula between two chopping sessions following the safety instructions.
 If you chop pieces of meat, cheese, we advise you to cut them into small pieces of 1 to
1,5 cm in order to obtain a homogeneous and fine chopping. Otherwise, you should
obtain pieces in your preparation.
 The mixer fitting has to be used only to mix liquids or non-solid food. Do not use it to knead
pastas but for example it is very useful to beat eggs white.
CLEANING
 Unplug from outlet before cleaning.
 You can wipe the motor block with a lightly damp cloth. Never immerse it in water or any
other liquid. If this happens, do not plug it in, let it dry for at least 24 hours before using it
again. If this is not enough, bring your appliance back to a competent qualified
electrician.
 To clean the blade, the container and the lid, use soapy water, rinse with clear water and
dry. Pay attention not to hurt you, as the blade is very sharp.
 To make the cleaning easier, you can disassemble the parts that are in contact with the
food, and the rubber ring around the container (if necessary you can soak it).
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must be reproduced and folded in order to obtain a mini
booklet A5 (+/- 148.5 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don't change the page numbering. Keep the language
integrity.
9
Assembly page 9/31
TEAM MC 1 - 060328