Troubleshooting - AWT TSL-Serie Montage- Und Bedienungsanweisung

Malfunction
Bathtub
1. Pool isn´t level
anomaly
2. The pump is idling
shaking and
3. pump failure
noising
1. Water intake blocked
2. Water level is low
Small
pressure 3. Inlet valve is closed
on the jets 4. Pump soaks air
5. Other reason
1. No power connection or
abnormal voltage
2. The fuse is burnt out or
Pump does damaged
not work 3. Control panel damaged
4. Water level sensor
damaged
Light does
1. Not connected
not work
2. Control panel damaged
Very slow 1. Low water pressure
inlet flow 2. The inlet pipe is blocked
1. The rubber ring in the
Valve does
not work valve body is deformed
Drainer does 1. Drainer / pipe blocked
not work
Some water
Proof the drainage
left inside
Reason Solution
1. Level the bathtub
2. Add some water until the water level is
higher than the water level sensor
3. Contact your dealer
1. Clean the water intake
2. Add some water until the water level is
higher than the water level sensor
3. Turn on the hydraulic regulator
4. Check if the air venting device is
blocked and return the rubber back to
the right position
5.
Contact your dealer
1. Check the power connection
2. Check the fuse
3. Contact your dealer
4. Add some water until the water level is
higher than the water level sensor
1. Check the connection
2. Contact your dealer
1. Check the water pressure
2. Check if the pipe is blocked
1. Change the water diverter valve
1. Check the drainage

Troubleshooting

39