Technical Data; Faq - ACME Blizz 200 Anleitung

3D HELI MASTER
3D HELI Master

Technical data

Helicopter model: Blizz 200 3D
Controller AC 2460H: 5-channel
Digital Proportion RC module, 2.4 GHz
Length: 238 mm
Width: 50 mm
Height: 93 mm
Weight: 50 g
Gyro system: Integrated
Receiver: AR 2460 (built-in)
Range: about 60 m

FAQ

Problem
LED on receiver flashes constantly and
no function works after switching on the
controller.
The helicopter does not respond after
connecting the battery to the receiver.
When pushing the throttle the rotor does
not move and the LED on the helicopter
flashes constantly.
Helicopter takes off as soon as batteries
and receiver are connected.
The propeller rotates constantly but the
helicopter cannot take off.
Helicopter vibrates or shakes whilst flying. Damaged rotor blades.
When taking off, the helicopter is out of
control.
The sound of the main rotor slowly dies
away.
Helicopter does not react or does not fly
smoothly.
Flight duration:
Charging time:
Motor:
Length of the rotor blades: 113 mm
Rotor diameter:
Tail rotor diameter:
Flight battery:
Battery charger:
Power adaptor:
Possible Cause
Controller and helicopter are not bound.
Either controller or helicopter might not
be connected to power.
Batteries of either sender or receiver
might be low.
Low battery
Connection between battery and receiver
board is bad.
Throttle is not in idle position.
Helicopter batteries low.
Main gear loose.
The blade grips on the lateral axis are
too tight.
Helicopter has not been static whilst
binding.
Helicopter battery low.
Failure of binding.
24
4 – 5 min.
20 min.
Brushed motor
249 mm
45 mm
LiPo 3.7 V 300mAh 30C
3,7 V LiPo Charger 1 Cell,
charging current: 0,1; 0,5; 0,7 Ah
110 – 240 V 1 A
Solution
Bind controller and receiver (see p. 21).
Check battery connections.
Replace and charge batteries.
Replace and charge the batteries.
Reconnect the batteries and the receiver board.
Put the throttle in idle position before switching
on the controller.
Replace and charge the batteries.
Press the gear spindle tightly.
Exchange main rotor blades
Loosen blade grips.
Rebind controller and helicopter correctly.
Charge battery.
Rebind helicopter and controller, make sure the
helicopter stays static during the process and is
placed close to the controller.