Landxcape LX791 Installationsanleitung Seite 9

2. Charge your Landxcape before the
TM
first operation
When connecting the power cord of the charging base to the adapter, align
the notch on the power cord (b) with the groove on the adapter (a).
Connect the adapter to the electrical outlet. The LED on the charging base
will turn on in green color. Manually dock Landxcape into the charging
TM
base while Landxcape is powered off. The green light on the charging
TM
base will be flashing and Landxcape will begin to charge.
TM
If the power cord is in Landxcape 's working area, you may bury it if
TM
desired.
NOTE: If you want to plug the adapter in an indoor electrical
outlet, you need to route the power cord through the hole in the
wall.
3. Peg the boundary wire
Before pegging the boundary wire, it is recommended to use a normal
lawn mower or a grass trimmer to cut the grass along the boundary. Then
the wire should be laid as close as possible to the ground to prevent your
RED BLACK
Landxcape accidentally cutting the wire. The boundary wire is powered
TM
with a very low voltage totally safe to humans and pets.
Pull out a length of boundary wire around 80cm and fasten it to the ground
near the charging base. Later, this end of the boundary wire (IN-wire) will
be connected to the BLACK terminal after pegging your boundry wire.
NOTE: The extended boundary wire should not exceed 400m or it may
cause signal problem.
EN 9