Landxcape LX791 Installationsanleitung Seite 12

Only for reference
LED light indicator on
the charging base
Light does not turn on There is no power.
Boundary wire is connected successfully;
Green light on
Landxcape
The boundary wire isn't connected.
Red light on
Power supply is connected successfully, while
the wire is connected unsuccessfully.
Green light flashing Landxcape
WARNING
• If your Landxcape TM is outside its territory, it will not move and "
Move it inside its territory and repeat Verification.
• If your Landxcape is inside its territory but "
TM
• Your Landxcape should always remain switched on. If you ever need to turn it off, then make sure you place it within its boundary area before you
TM
switching it back on again.
• Should your Landxcape stop operating, simply restart it and operate it as you normally would.
TM
NOTE: Please refer to the Owner's Manual for more information.
Only for reference
12
Status
TM
is fully charged.
TM
is auto charging.
" is displayed, please refer to "Error Messages" in Owner's Manual for solutions.
4. Press then to send Landxcape
Landxcape will follow the boundary wire to the charging base.
TM
5. Fine tune the outline shape of the boundary wire if necessary.
NOTE: If the boundary wire is broken during the testing or you need to
extend the boundary wire, please refer to "Joining the Boundary Wire"
in Owner's Manual for instructions.
Check the status of the LED light indicator on the charging base to make
sure the connection is OK.
If the verification test is completed smoothly, you can start mowing by
pressing then .
If there is any problem during verification test, please refer to "Owner's
manual-Troubleshooting".
Confirm that the power cord is connected properly to the charger and that
the charger is connected to a suitable power supply.
/
Confirm that there are no breaks in the boundary wire.
Check that the boundary wire has been connected correctly to the
charging base.
Confirm that there are no breaks in the boundary wire.
/
" will be displayed.
Setting
First please set the height to a desired grass level after cut and you can
do the program setting manually.
NOTE: When doing the program setting manually, Landxcape
enter the standby page if it does not receive any input from the user
within 30 seconds.
1.Change PIN code
To change the PIN code, keep pressing both
same time for 5 seconds. The icon
" will be rolling flashing. After that, the first number will be blinking, use
or to select the number you want and press
next number will be blinking. Use the same method to complete other
numbers. For example, the new PIN code is set to be 0326. After that, "
" will be rolling flashing and the first number will be blinking
again. Use the same method to input the new PIN code you set just
now (in this example,
flashing on the display. Your PIN code has been changed successfully.
TM back to the charging base.
Action
will
TM
and buttons at the
will be blinking, and "
to confirm. The
). Then " " will be rolling
EN