Access The Product; Reset To Factory Default Settings; Further Information - Axis F41 Installationshandbuch

7. If required, attach the RS232 cable to connect to auxiliary
equipment.

Access the Product

Use the tools provided on the Installation and Management Software
CD to assign an IP address, set the password and access the video
stream. This information is also available from the support pages on
www.axis.com/techsup/

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to
factory default will reset all settings, including the IP address,
to the factory default values.
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See
Hardware Overview on page 10.
3. Keep the control button pressed for about 15–30 seconds until
the status LED indicator flashes amber.
4. Release the control button. The process is complete when the
status LED indicator turns green. The product has been reset to
the factory default settings. If no DHCP server is available on
the network, the default IP address is
5. Using the installation and management software tools, assign
an IP address, set the password, and access the video stream.
It is also possible to reset parameters to factory default via the web
interface. Go to Setup > System Options > Maintenance.

Further Information

The User Manual is available at www.axis.com
AXIS F41 Main Unit
192.168.0.90
21