Connecting An Optical Edge Detector; Connecting A Printer - HEIDENHAIN QUADRA-CHEK 2000 Installationsanleitung

5.4 Connecting encoders
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the product",
Page 23
Connect the encoder cables tightly to the respective
connections
Further information: "Product overview", Page 25
If the cable connectors include mounting screws, do
not overtighten them
Pin layout of X1, X2, X3
Further information: "1 V
SS
Pin layout of X21, X22, X23
Further information: "TTL", Page 178
5.5

Connecting an optical edge detector

Remove and save the dust protection caps
Route the fiber-optic cable depending on the mounting
variant
Further information: "Assembly of the product",
Page 23
Adhere to the manufacturer's
specifications regarding the maximum
bend radius of the fiber-optic cable
Connect the fiber-optic cable of the light source
(reference) to connection X107
Connect the fiber-optic cable from the projection
screen to connection X108
Further information: "Product overview", Page 25
Pin layout of X107, X108
Further information: "OED", Page 178
26
", Page 178
5.6 Wiring switching inputs and outputs
Depending on the peripherals to be
connected, the connection work may need to
be carried out by an electrical specialist.
Example: Safety Extra Low Voltage (SELV)
exceeded
Further information:
Page 20
The encoder fulfills the requirements of
standard IEC 61010-1 only if the power to
the peripheral devices is supplied from a
secondary circuit with current limitation as per
IEC 61010-1 3rd Ed.
limitation as per IEC 60950-1
2.5 or from a Class 2 secondary circuit as
specified in UL1310.
In place of IEC 61010-1
corresponding sections of standards DIN EN
61010-1, EN 61010-1, UL 61010-1 and CAN/
CSA-C22.2 No. 61010-1 and, in place of IEC
60950-1 2nd Ed. , Section 2.5, the corresponding
sections of standards DIN EN 60950-1, EN
60950-1, UL 60950-1, CAN/CSA-C22.2 No.
60950-1 can be applied.
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the product", Page 23
Connect the connecting cables of the peripherals
tightly to their connectors
Further information: "Product overview", Page 25
If the cable connectors include mounting screws, do
not overtighten them
The digital or analog inputs and outputs must
be assigned in the device settings of the
respective switching function.
Pin layout of X 113
Further information: "X113", Page 179
5.7

Connecting a printer

Connecting a USB printer
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the product",
Page 23
Connect USB printer to USB type A connection (X32).
Make sure the USB cable connector is fully inserted
Further information: "Product overview", Page 25
Pin layout X32
Further information: "USB", Page 178
HEIDENHAIN | QUADRA-CHEK 2000 | Installationsanleitung | 06/2018
"Personnel qualification",
, Section 9.4 or with power
2nd Ed. , Section
3rd Ed. , Section 9.4, the