Herunterladen Inhalt Inhalt Diese Seite drucken

Anschluss / Connection - Saro PG 1 Betriebsanleitung

Elektro-kontakt grill
Inhaltsverzeichnis

Werbung

SICHERHEITSHINWEISE
Sollte das Gerät doch einmal in Brand geraten:
Netzstecker ziehen und nur mit einer Löschdecke oder
einem Fettbrandlöscher löschen.
Nie mit Wasser, da eventuell heißes Fett /Öl durch den
Kontakt mit Wasser großfl ächig spritzen und kleine
Brände verteilen würde
Vorsicht beim Öff nen des Deckels. Das Gesicht nicht
direkt über das Gerät halten,
Spritzgefahr und eine kurzzeitige, starke Hitzewelle
steigt empor.
ANSCHLUSS
Bevor Sie das Gerät anschließen, vergewissern Sie sich, dass
die Spannung und die Frequenz der Stromversorgung mit den
Angaben auf dem Typenschild übereinstimmen!
Verfügt das Gerät über einen Netzstecker Anschluss, stecken
Sie den Netzstecker in eine geeignete, geerdete Steckdose.
Sollte das Gerät nicht über einem Netzstecker Anschluss
verfügen, lassen Sie die Installation unbedingt von einem
Fachmann vornehmen!
WARNUNG: BRANDGEFAHR!
Platzieren Sie das Gerät nicht in der Nähe von
entzündlichen Materialien oder Flüssigkeiten! Zu allen
Seiten muss ein ausreichender Abstand eingehalten
werden!
WARNUNG: GEFAHR DURCH
ELEKTRISCHEN STROM!
Vergewissern Sie sich, dass das Stromkabel frei von
Beschädigungen ist.
Ein beschädigtes Gerät darf nicht benutzt werden! In
diesem Falle wenden Sie sich an Ihren Fachhändler!
Vor dem Anschluss ans Netz prüfen Sie, ob die Stromart
und die Netzspannung mit den Angaben auf dem
Typenschild des Gerätes übereinstimmen.
Lassen Sie den Anschluss ggf. von einem Fachmann
übernehmen.
Verwenden Sie keine Adapter oder Verlängerungskabel.
SAFETY NOTICES
If the device should catch fi re after all: Pull out the mains
plug and extinguish only with an extinguishing blanket
or a grease fi re extinguisher.
Never with water, as hot fat/oil may splash over large
areas due to contact with water and spread small fi res.
Take care when opening the lid. Do not hold your face
directly over the device,
Danger of splashing and a brief, strong heat wave rises.
CONNECTION
Before connecting the device, make sure that the voltage and
frequency of the power supply correspond to the information
on the type plate!
If the device has a mains plug connection, plug the mains
plug into a suitable, earthed socket.
If the device does not have a mains plug connection, it must
be installed by a specialist!
WARNING: DANGER OF FIRE!
Do not place the device near fl ammable materials or
liquids! A suffi cient distance must be maintained on all
sides!
WARNING: DANGER FROM
ELECTRIC CURRENT!
Make sure that the power cable is free of damage.
Damaged equipment must not be used! In this case
please contact your specialist dealer!
Before connecting to the mains, check that the type
of current and the mains voltage correspond to the
information on the type plate of the device.
If necessary, have a specialist take over the connection.
Do not use adapters or extension cords.
Stand 04/2018 SR TM
7

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Pg 1bPg 2

Inhaltsverzeichnis