Lanaform Pure Bedienungsanleitung Seite 6

Instructions for use (see illustrations at the beginning of the instructions for use)
1) Place the "PURE" essential oils humidifi er and diff user in the room half an hour before lighting it so that it can adjust to room
temperature.
EN
2) Make sure it is always placed on a hard, fl at and horizontal surface (a). Always keep it away from walls and heat sources such
as stoves, radiators, etc.
3) Make sure the device is clean before starting to use it.
4) Remove the reservoir and keep it upside down. Turn the reservoir lid in an anti-clockwise direction to open it. Then pour
distilled or demineralised water into the reservoir. Replace the lid and turn in a clockwise direction to close it tightly (b).
Finally, put the reservoir on the base of the device, making sure it is correctly positioned (c).
5) Make sure your hands are completely dry when connecting and disconnecting the device and if they are not, then dry them.
6) Connect the power supply plug to the device and to the electric socket (d).
7) Select the mode you want, either "humidifi er" or "essential oils diff user".
"Humidifi er" mode
Just choose one of the two nozzles and fi x it onto the reservoir (e) (f).
"Essential oils diff user" mode
You must position the cold-mist emission reducer (g) and the ring with the foam tab for the essential oils (h) before
fi xing one of the two nozzles to the reservoir. Once the ring is in position with the foam, just impregnate it with a
few drops (3 to 4 drops at most) of essential oils to ensure the device is working properly and diff using a pleasant
scent (i).
8) Press the on/off button, the light will come on and the device will start to work.
You can either use the device in continuous mode or programme it with the timer.
In continuous mode:
Press the on/off button to adjust the cold-mist level, the light will change colour and a beeping sound will be heard.
See chart below for further options:
Press the on/off button
Press once
Press twice
Press 3 times
Press 4 times
In timer mode:
- Start by selecting a colour that corresponds to the level of vapour emission required.
- Press the on/off button for 3 seconds, the light will fl ash with the colour selected. The length of time it fl ashes will
automatically be linked to the colour you have selected.
- If you wish to change the length of time, press the button again once and you will see that this button will fl ash for +/- 1
second and the background colour will change for the period in which it is fl ashing.
6
Light
Red
Green
Blue
Th e h u m i d i f i e r / d i f f u s e r s t o p s
Cold mist level
Low
Medium
High