kbs EK 4 Handbuch Seite 16

Be very careful not to wet the tempered glass door while still hot as this could cause it to
fracture.
Do not cover the cooking chamber walls with oven-proof paper or aluminium foil.
Do not interfere with the safety devices fitted to the oven.
The operations described in this manual are the only ones the user is authorized to carry
out without specialist assistance.
The oven must be positioned on a flat surface at least 10 cm from the wall to ensure
adequate ventilation.
The oven is equipped with a vapour/smoke extractor. This must be hooked up to a
chimney and fitted with a condensation release point so that no water can gain access to
the inside of the oven.
Make sure that in the immediate vicinity of the oven there is no electrical apparatus which
may be disturbed by the electrical field which is produced.
Keep this manual in a safe place as it should be passed on to the purchaser if the oven is
resold.
For any repairs necessary, only use official spare parts recommended by the manufacturer.
Contact the service centre for advice.
Lack of observation of the above recommendations could compromise both the equipment
and operator safety.
It is recommended that the oven be thoroughly checked on delivery.
When making connections always observe local building and fire safety regulations.
3.
1 Technical characteristics
The oven had been constructed using sheet steel specially treated to withstand high
temperatures, a cooking surface in refractory material and a frame insulated with rockwool and
fibre.
The heating unit consists of two groups of electrical elements, one located at the top and one at
the bottom of the cooking chamber with separate controls.
EK series ovens with electro mechanic control allow the cooking process to be regulated by means
of a thermostat the former type.
These heat regulation devices have been designed with a view to allowing the operator to set the
devices according to requirements with the simplest of operations.
Lighting inside the cooking chamber is provided by a heat shielded light bulb.
EK
CHAP.3 - EQUIPMENT DESCRIPTION
16