Bushnell NorthStar GOTO 78-8850 Bedienungsanleitung Seite 17

M
ALIGNING NORTHSTAR FOR THE FIRST TIME / ALIGN STAR MODE
To select the final mode press ENTER at the display:
SELECT MODE
TELESCOPE 56
The display reads something like:
RA18:53 DEC+38.7
AZ280 ALT+62 LYR
The TELESCOPE mode gives you dynamic real-time information on your telescope's current position in terms of
astronomical coordinates. Play around with this mode by moving the telescope around. Notice the three letter
abbreviation in the lower right portion of the display. This dynamically displays the current CONSTELLATION that the
telescope is pointing at. These names are abbreviated in this mode. Definitions for the abbreviations are listed in an
index at the back of the manual.
optionaL: using aLign star moDe (two star alignment method)
This mode requires you to locate and center two stars instead of just one, so it may take a little more time and
experience. However, it will provide more accurate, precise operation and guidance as you continue to use your
NorthStar telescope. It's also useful if you are in a remote location and can't find a nearby city from the list in ALIGN
EARTH mode.
To use the ALIGN STAR mode, after you turn on the telescope's power and the SELECT MODE message appears on the
display after the welcome message, press the DOWN button to select ALIGN STAR. Press ENTER. The message changes
to ALIGN STAR 1.
Using the star charts on the next pages for reference (there is a chart for each of the four seasons, in both northern
and southern hemispheres), choose a star you think you will be able to find in the night sky (perhaps within one of the
constellation groups), and use the UP/DOWN buttons to find it's name on the displayed list. The display also shows two
numbers with vertical and horizontal position arrows. Pressing "GO" will move the telescope into a position roughly
near the star. Now use the red dot finder scope to aim the telescope more precisely at the star you chose. Next, looking
through the eyepiece, position that star right in the center of the viewing field by moving the telescope by hand or
using the motorized movement buttons).
Once you have your first star centered, press ENTER. The display changes to "ALIGN STAR 2". Select another star from
the list (again using the star charts for reference) and repeat the process for the second star. After this step is completed,
you will see a display that reads:
ALIGN COMPLETE
RATING *****
(Note: The more stars that appear on the second line of the display the better, up to 5)
The telescope is now aligned and ready to use. The display will again read SELECT MODE. Please refer to the directions
and suggestions in Step 6: "Explore the Night Sky". For example, you might start off selecting the EXPLORE mode,
then selecting PLANET if you are new to the world of astronomy.
17