Set The Clock Manually; Alarm; Basic Functions; Displaying Alarm Time - Oregon Scientific Jumbo JM889NR Bedienungsanleitung

Clock signal reception indicator:
Strong Weak No
signal signal signal
NOTE It takes 2-10 minutes to receive the clock
signal. If the signal is weak, it could take up to 24 hours
to receive a valid signal.
To enable/disable signal reception:
Press and hold and .

SET THE CLOCK MANUALLY

1. Press and hold / to disable signal reception.
2. Press and hold Clock. The screen displays ZONE
and the number flashes.
3. Press once or press and hold
setting. For EU/UK, the time-zone offset sets the
clock up to +/- 23 hours from the received clock
signal time. For US, the time-zone setting is 0(P),
1(M), 2(C), 3(E).
4. Press Clock to confirm.
5. Press once or press and hold
setting for 12/24h hour format, hour, minute, year,
calendar format (month-day/day-month), month,
date, language and temperature unit (
6. Press Clock to confirm.
NOTE
German (D), French (F), Italian (I), and Spanish (S).
Receiving
To select the display mode:
signal
Press Clock to select between seconds and
weekday display.
NOTE When the temperature is lower than -5
the screen displays LL.L. When the temperature is
higher than 50

ALARM

BASIC FUNCTIONS

1. When the daily alarm goes off, press Alarm to stop.
2. The alarm will stop after 2 minutes. Then it will go

DISPLAYING ALARM TIME

/ to adjust the
1. Press Alarm when the screen displays the current date.
2. To display the current date, press Clock when the

SET THE ALARM

1. Press and hold Alarm. The hour of alarm
/ to adjust the
2. Press once or press and hold
C/ F).
o o
3. Press Alarm to confirm.
4
The language options are English (E),
C (122.0 F), the screen displays HH.H.
o o
off again after 8 minutes unless Alarm is pressed.
screen displays the alarm time.
display flashes.
the settings.
displays.
o C (29.0 o F),
/ to change