CMT ORANGE TOOLS CMT3000 Gebrauchsanweisungen Seite 7

ELLIPSE CUTTING
Minor semi-axis setting
(Fig. 7) Rotate the router by 90°. The cross frame (1) must not be rotated! The complete slider (B)
is at the centre of the cross frame). Set the required minor semi-axis length by moving the extension
(4) and (5) in the slider pin (B); the complete slider (A) remains tightened. Once the minor semi-
axis has been set, tighten the bolt (7) of the complete slider (B).
Fig. 7
Attention: If the work piece is bent or warped, the complete sliders (A) and (B) may block in the
slots of the cross frame (1), so only perfectly flat material must be used.
Shorter axis L2
MIN
2590
1590
1390
1290
1090
990
890
790
690
620
620
620
620
Minimum possible combination
5
A
Major axis L1
MAX
2890 3000
1890 2000
1690 1800
1590 1700
1390 1500
1290 1400
1190 1300
1090 1200
990 1100
920 1030
790 900
690 800
620 730
B
B
www.cmtutensili.com
A