CMT ORANGE TOOLS CMT3000 Gebrauchsanweisungen Seite 4

ASSEMBLY
(Fig. 1) Fit the guide rods (6) into the connector plate (3) and tighten with M5x16 screws (12) and
washers (11). Screw the control bolts (7) into the slider pins (2).
Put the slider pins (2) into the slots in the cross frame (1). Fit the threaded extensions (5) and (4)
together, fit the threaded extension into the groove of the connector plate (3) and tighten with the
screw M8x20 (8) and washers (9) and (10).
Fit the complete sliders (A) and (B) into the guide slots of the cross frame, fit the previously
assembled extension rod into the holes in the pins of the complete sliders and tighten bolts (7) on
the relative slider pins. Assembly is now complete.
7 7
B
A
2 2
Fig. 1
www.cmtutensili.com www.cmtutensili.com www.cmtutensili.com
5
4
3
5
9
10
Utensili necessari Utensili necessari JIG ASSEMBLY
8
6
6
2 2