Overload Protection; Maintenance And Care - Flex CSM 4060 Bedienungsanleitung

Portable circular saw for metals CSM 4060
Operation
Caution!
After the power tool has been switched off,
–
the saw blade continues running briefly.
When the running saw blade touches the
–
workpiece, the power tool may recoil.
Sawing
Note!
Excessive feed reduces the performance
of the power tool, impairs the cutting quality
and reduces the service life of the saw
blade.
Take hold of the handle (1) with your right

hand and the additional hand grip (6) with
your left hand.
Switch on the power tool and wait until the

saw blade has reached the maximum
speed.
Slowly bring the power tool towards

the material.
Guide the power tool through the material

at a uniform feed.
Parallel stop
Facilitates cuts parallel to the edge of the
workpiece.
Loosen the wing screw (8).

Set the parallel stop (18) to the required

width.
Tighten the wing screw (8).


Overload protection

If there is an extreme overload, the overload
protection system protects the motor from
damage by automatically switching off the
power tool.
Release the safety switch (4).

Pull out the mains plug.

Leave the appliance to cool down for

at least 3 minutes.
Press the overload protection reset

button (2).
The power tool is ready to use again.

Maintenance and care

Danger!
Before carrying out any work on the power
tool, always pull out the mains plug.
Cleaning
Danger!
Impairment of the protective insulation!
If metals are sawn over a prolonged period,
conductive dust may become deposited
inside the housing.
Operate the power tool via a residual-
current-operated circuit-breaker
(tripping current 30 mA).
Regularly clean the power tool and

ventilation slots.
Regularly blow out the housing interior and

motor with dry compressed air.
Pendulum guard
Danger!
The pendulum guard (19) must always
move freely and close independently.
Always keep the pendulum guard and
return spring clean.
Remove dust and chips with a paint brush

or dry compressed air.
Sawdust guard
The discharge of sawdust and collection in
the sawdust guard (15) can be observed via
the window (12).
Empty the sawdust guard when it is approx.
half full.
Caution
Metal sawdust is very hot. Do not touch with
bare hand.
21