Setting The Cutting Depth; Switch On And Off - Flex CSM 4060 Bedienungsanleitung

Insert the saw blade in the correct position.

Attach the front clamping flange (20 b) with
the flange on the outside and manually
tighten the locking screw (20 a) in
a clockwise direction.
Press and hold down the spindle lock (9).

Tighten the locking screw (20 a) in
a clockwise direction with an Allen key.
Attach the sawdust guard (15) and secure

with the Allen screws (7).

Switch on and off

Note
For reasons of safety the safety switch (4)
is not locked and must be held down during
sawing.
Switching on:
Press and hold down the starting

lockout (3).
Press and hold down the safety switch (4).

Release the starting lockout (3).

Switching off:
Release the safety switch (4).

20
Portable circular saw for metals CSM 4060

Setting the cutting depth

Note
For optimum cutting results the saw blade
may project out of the workpiece by max.
3 mm.
Pull out the mains plug.

Loosen the clamping lever (10).

Set the required cutting depth:

Lift the saw off the base plate (11) = lower
cutting depth.
Tighten the clamping lever (10).
