Epson EMP-TW10H dreamio Bedienungsanleitung Seite 20

Troubleshooting
fImage is out of focus (unclear)
• The image is fuzzy
• Part of the image is
out of focus
• The whole image
is out of focus
fImage is distorted / Image contains interference
fOnly part of the image is displayed (large/small)
fImage colours are poor, tinted green or tinted red/purple
18
-When You Suspect a Problem
• Is the projector at the
correct distance from the
screen?
• Is the lens dirty?
• Has condensation formed
on the lens?
• Has the focus been
correctly adjusted?
• Is an extension cable
being used?
• Are the cables connected
correctly?
• Is the aspect ratio set
correctly?
• Has the "Position" been
adjusted correctly?
• Does the lamp need
replacement?
• Adjust each of the settings
in the following menus.
[Menu] button → "Image"
→ "Picture Quality"
• Are the cables connected
correctly?
http://www.pureglare.com.au
The optimum range for projection is 73-1165cm (2.4-
38.2ft.). Set the projector within this range.
s "Installation method" P.8
s "Cleaning the lens" P.20
If the projector is suddenly taken from a cold environment
to a warm environment, condensation may form on the
surface of the lens, and this may cause the images to
appear fuzzy. Set the projector up in the room in which it
is to be used approximately one hour before use. If
condensation forms on the lens, turn off the power and
wait for the condensation to disappear.
Turn the focus ring to adjust the focus.
If using an extension cable, electrical interference may
affect the signals.
Check that the cables are securely connected.
Interference may occur if the cables are not connected
securely.
Press the [Aspect] button to change the aspect ratio.
s "Changing aspect ratio" Quick Reference Guide
Use the "Setting" → "Screen" → "Position"
configuration menu to correctly adjust the display
position.
When the lamp is due for replacement, colours will
weaken and the image will become dark. Replace the lamp
when this is the case. s "Lamp replacement period" P.22
"Contrast", "Color Temperature"
"Saturation", "Tint", "Brightness"
If cables connecting to component video equipment are
not connected securely, certain colours may not be
displayed.