Dmx In / Out Sockets - Nowsonic AUTARK ID07 Bedienungsanleitung

Nowsonic Autark ID07
GB
User manual
4.
BATTERY SWITCH
This button activates the operation of Autark
battery pack. The internal battery pack is automatically charged when
Autark is connected to the mains. The charging capacity of the
ID07
battery pack is displayed on the battery indicator (6).
5. Remote antenna
The antenna is connected to the internal
Unfold the antenna to improve the reception quality for remote con-
trolling.
6. Battery indicator
These s show the current charging status of the internal battery
LED
pack: when fully charged (all
up to 10 hours without mains supply.
7. Signal
LED
When the automatic sound control mode is active, this
depending on the sensitivity set in the S! L n5 menu (see from page 7
on). The brighter the LED
via the internal
ID07
receiver of Autark
DMX
s are lit), Autark can be operated
LED ID07
lights up, the higher the sensitivity is.
8. /
DMX IN OUT
These sockets allow to feed an external
to loop thru the incoming
In Master/Slave mode, the Master device outputs the control signal
DMX OUT
via its
DMX IN socket.
. NOTE: Please note that the last unit in a daisy chained configura-
ID07
tion via DMX
termination resistor. Otherwise control problems may arise.
9. Earthing point
This screw allows to connect external devices with the ground of
Autark .
ID07
Operation
You can operate Autark
LED lights mode or wired and remotely controlled respectively via
alone mode, the sound sensing is automatically activated and toggles
the internal programs depending on the detected music signal.
10
sockets
signal to Autark
DMX
signal to following Autark devices.
DMX
socket, while the Slave unit receives the signal via its
or in Master/Slave mode should be terminated by a
either in Stand-alone or Master/Slave
ID07
www.nowsonic.com
and
ID07
DMX . In Stand-