Problem Solving; Technical Specification - Enodis Merrychef Microcook HD Benutzerhandbuch

PRObLeM SOLVING

error code display
The oven will identify some of the most common problems by flashing an error message
code in the time display window.
error code display
Please remember - No servicing or repairs should be carried out other than by an approved Service engineer
Technical Specifications
Microcook HD05 & HDV05
Microcook HD45 & HDV45
Microcook HD75 & HDV75
Microcook HD95 & HD95
Microcook HD05
Manufacturers recommended
clearances
Power Supply: See rating plate at rear of oven
This equipment complies with the following EEC directives:
EMC 89/336 EEC
LVD 73/3 EEC
Merrychef reserves the right to alter specifications without prior notice.
Fault
Door not fully shut.
Possible electrical fault
Oven has overheated
No time has been set.
Invalid time has been set. e.g. 6secs
The required cooking time for multiple
items exceeds 30minutes
Display shows 0:00 but the cavity light
and cooling fans do not operate
Control panel lights do not operate with
oven connected to electrical supply.
Height Width
( mm ) ( mm )
489 500
489 500
489 650
50 50*
each side
5
Recommended action
Close door fully.
Call Merrychef Service Dept.
Clean air filter and vents
Leave oven switched on but not cooking
for 4-5 minutes.
Set a time
Set time in correct format :0
Remove one item and try again
Oven has gone into 'stand-by' mode, press
any pad to restart.
. Check oven is connected to electrical
supply
. Check fuse is correct value and in good
order.
3. Call Merrychef Service Dept.
Microwave
Depth Wt.
Power output
( mm ) ( kgs)
( watts )
45 05
40
4.5 45
500 4.5 75
4.5 95
500 4.5
05
50
For 2 ovens side by side clearance is 100mm
*
Pt No. 3Z3046GB Issue 5