Operating Instructions: Manual Mode - Enodis Merrychef Microcook HD Benutzerhandbuch

OPeRATING INSTRuCTIONS: MANuAL MODe (Microcook HD Models)
The oven can be operated in
manual or programmed mode. It is
important to understand manual
mode prior to attempting program
operation.
1 Place the food in the oven and
close the door.
2 Set required cooking time by
pressing the numeric TIME
SELECT PADS.
Example: 2 Minutes 35 seconds
Only valid times of Minutes and Seconds
will be accepted.
e.g. minute  second not 61 secs
3 To cook the food press one of
the POWER PADS either 00%,
50% or Defrost.
The LED within the selected pad
will light.
4 The timer will now count down.
When the remaining time
reaches zero the door will open
automatically. Remove the food
from the cavity.
Note:
The automatic ' Pop-up ' door
is not fitted to Microcook
HD05ML & HDV05ML
models.
At the end of the cycle an
audible signal will be given and
the door on these models must
be lifted open manually.
5 Test the food with a
temperature probe to To
ensure the required core
temperature has been
reached. Replace food and
cook for a little longer if
necessary.
DO NOT APPLY MICROWAVe eNeRGY WHeN OVeN IS eMPTY
DO NOT uSe THe OVeN WITHOuT
CLeAN AIR FILTeRS IN POSITION
To familiarise yourself with the controls place a bowl containing
approximately .5 litres of water in the oven prior to operation.
time
2
time
3
time
5
100% 50%
0
WARNING:
MAXIMuM TIMe
The time set cannot exceed
9 minutes 59 seconds
Total cooking for multiple items
cannot exceed 30 minutes.
( If 30 minutes is exceeded error
code E:3 will be displayed)
TO STOP THe COOk CYCLe
The cycle may be stopped and
cancelled at any time by pressing
the CANCEL PAD
PAuSe
The cycle may interrupted by
opening the oven door.
On opening the door the timer will be
held at this point and the light on the
relevant POWER PAD (microwave
or convection) will flash to indicate
an interrupted cycle.
TO CONTINUE the cycle close the
door, an audible warning sounds as
a reminder to press any power pad
to restart the timer.
'STAND bY' FACILITY
To conserve energy and extend
the life of components, the oven
will go into 'standby status if not in
use for approximately 5 minutes.
The interior light will go out, the
fans will stop and the displays will
dim.
Simply touch any pad to restart the
oven