Programing Number Pads - Enodis Merrychef Microcook HD Benutzerhandbuch

PROGRAMMING NuMbeR PADS ( 0-9 )
Pre-programming allows repetitive cooking procedures to be stored for ease
of use.
Each program can comprise up to three stages, allowing at each independent
control of Stage time and Microwave power level. However, programs must be
used with caution since if the food to cook varies in weight or density then good
results and more importantly adequately cooked food may not be achieved.
Therefore, it is vital that all food prepared for service should be checked to
ensure that core temperatures have been achieved.
(Note: Model 05 has only a single stage program)
 Press and hold PROGRAM PAD
until a flashing 'P' appears in the
PROGRAM DISPLAY
 Enter required cooking time by
pressing the TIME SET PADS
(The display colons flash to indicate
a time is required).
Only valid times of Minutes and
Seconds will be accepted.
e.g.  minute  second not 61 secs
3 Select the power setting press
one of the POWER PADS
00%, 75%, 50% or Defrost.
The LED within the selected pad
will light.
To save as a single stage program
Press the required number pad
example: stage 1 saved as Program 8
Program Program
1 1
2 2
3 3
time
The program details are displayed
momentarily as the program is
saved.
2
3
5
To save a multi-stage program
Follow steps – 3 for each stage
of cooking and on completing
press the PROGRAM PAD to
enter a second and third stage
of cooking to the program. Press
the required number pad to save
the program.
8
example: stage 1, stage 2, stage 3
saved as Program 8
Program Program
1 1
2 2
3 3
Program Program
1 1
2 2
3 3
P
Program Program
1 1
2 2
3 3
time
time
time
100% 50%
time
P
time
P
time

An amount of experimentation
will be required to determine
the correct program for a
particular product.
CALL bACk
To review program details
use CALLBACK.
Press and hold CANCEL
until a flashing 'C' appears in
the program display
C
Press the number pad for the
program you wish to check and
the details will be displayed.
We recommend you keep a note
of program instructions for future
reference
8
Program Program
1 1
2 2
3 3