General Notes; Safety; Identification Obligation - Graf CARAT XL Einbau-/ Montage-/ Und Wartungsanleitung

1.1

Safety

The relevant accident prevention regulations according to
BGV C22 must be observed during all work. Particularly
when walking on the tanks, a 2nd person is required to
secure the tank.
The relevant regulations and standards must additionally be
taken into consideration during installation, assembly,
servicing, repair, etc. Relevant notes can be found in the
corresponding sections of these instructions.
During all work on the system or parts of the system, the
entire system must always be rendered inoperable and
secured to prevent unauthorised reactivation.
Except in the event of work carried out in the tank, the cover
of the tank must always be kept sealed, as this otherwise
constitutes a maximum risk of accident. The rain protection
installed on delivery is merely transportation packaging. It
cannot be walked on and is not child-proof; it must be
replaced with a suitable cover immediately following delivery
(telescopic dome shaft with corresponding cover)! Only
original GRAF covers or covers approved in writing by GRAF must be used.
GRAF offers an extensive range of accessories, all of which are designed to match each other and which
can be extended to form complete systems. The use of accessories that have not been approved by
GRAF results in the exclusion of the warranty/guarantee.
1.2

Identification obligation

All service water pipes and outlets must be identified in writing with the words "Not drinking water" or in
the form of images (DIN 1988 Part 2, Para. 3.3.2.) in order to avoid inadvertent connection with the
drinking water mains even after a number of years. Mix-ups, e.g. by children, may still occur even in the
case of correct identification. All service water extraction points must therefore be installed with valves
with child-proof locks.
info@graf.info
www.graf.info
1.

General notes

12 / 50