Werbung
REGISTER A SENSOR
Use the app to register a sensor when the alarm is connected via Wi-Fi or GPRS. When
only GSM connection is available, the registration must be done manually via buttons
on the alarm system front (see the main manual). Open the app and select Wi-Fi or
GPRS. Press Control in the lower left corner and then press Enrolment for registration.
Select the type of sensor, remote control, sensor or RFID. Select an available zone. Press
the sensor button (see the sensor manual). The sensor is now registered. To get the
entry time of a sensor, register it with Zone type, Delay/Entry. Zone type is configured
under the Zone tab in the app. Select zone type Burglar etc. In zone type Smart the
sensor must be triggered twice within 40 seconds to trigger the alarm. A great feature
in difficult environments where false alarms can easily occur. Change the name of the
sensor under Zone name. The entry time can be changed under System, Delay time and
Alarm delay. A smoke detector is registered as Fire. In addition to Zone type, Home arm
mode must be configured for each sensor. In Home arm mode OFF, the sensors are
passive when the alarm is on.
Note! Press the checkmark in the upper right corner for the changes in the app
to take effect.
MATRIS ZONE TYPER:
Zone Type
Bortkoppla
Ingång
Inbrott
Perimeter
Brand
Gas
Tyst larm
Panik
Sjuk
Dörrsignal
Smart
For declaration of conformity please visit Electia's website
Art: 11 241
Alarm Delay
-
√
-
-
-
-
-
-
-
-
-
Output Alarm
Voice
-
√
√
√
√
√
-
√
√
-
√
Arm
Disarm
-
√
√
√
√
√
√
√
√
-
√
www.electia.se
-
-
-
-
√
√
√
√
√
-
-
Werbung
