Werbung
Alarm EL-20 / W20
Introduction and Quick Guide
The alarm system can be connected via WI-FI, GPRS and GSM.
If you have no broadband, the alarm can be controlled via a SIM card with GPRS
and/or GSM. When selecting GPRS, please note that the data traffic is about 30MB/
month. When choosing SIM card it is important to make sure that the SIM card has
data traffic and SMS as well as that it works on 2G networks. The PIN code of the
SIM card must be disabled.
Selecting an option or a combination of Wi-Fi / GPRS / GSM is done in the Smart
Alarm app, which is available for IOS and Android. The safest way is to use both
Wi-Fi and SIM card (GSM/GPRS) to have a backup in case one of the systems fails.
In the app, select the language under the Personal tab. Insert your telephone num-
ber, external siren setting etc. in the System tab
The alarm comes in a KIT with magnetic sensors: 1 magnet, 1 PIR, 2 remote con-
trols and 2 pre-programmed RFID tags. Via the app, it is easy to change the function
of the sensors and its name. The entry time on a sensor is registered with zone type
Delay/Entry. The Zone type function is configured under the Zone tab in the app.
Select zone type. You can change the name of the zone under Zone name. The entry
time can be changed under System, Delay time and Alarm delay.
The alarm generates push messages when a Wi-Fi / GPRS connection is established
and text and speech (calls) when SIM card and a combination of options are selec-
Built-in high power capacity
least.
ted, if so desired.
Support
100
pieces of latest alarm records and querying via APP.
Increase the function of voice prompts, alarm voice prompts
The GSM module is 2G, Wi-Fi: 2.4 GHz, and the radio module for sensors is 433MHz.
Increase the external bell interface, can work with 5V alarm through 3.5mm audio
The alarm system has battery backup and sends a message in case of a power failu-
cable
re. We recommend replacing the sensor batteries once a year. A warning message
is sent when the battery level is low.
In order to increase security and prevent "hacking" of the alarm it is important to
change the factory-set codes via the app after the alarm system is registered for the
first time. Write down the codes and keep them in a safe place.
ARMING/DISARMING THE ALARM AND CONFIGURING SETTINGS IN THE
ALARM SYSTEM
Use Remote control, token, RFID tag and app to arm/disarm the alarm. The easiest
way to configure all settings is via the app. Use the QR code below to load the Smart
Alarm app.
Built-in high power capacity
least.
Support
Increase the function of voice prompts, alarm voice prompts
Increase the external bell interface, can work with 5V alarm through 3.5mm audio
cable
800mAh 3.7V
lithium battery can be standby
SIM card
Mic
DC in
seating
Bell
battery switch
3,5mm
Indicator light
800mAh 3.7V
100
pieces of latest alarm records and querying via APP.
8
hours at
SIM card
Mic
seating
Arm
button
lithium battery can be standby
DC in
Bell
battery switch
3,5mm
Indicator light
WiFi
button
Enroll button
8
hours at
Werbung
