Using The Tuner - Tascam CD-GT1 Bedienungsanleitung

Using the tuner

 e s builtin guitar tuner  e s builtin guitar tuner
has two modes an automatic mode has two modes an automatic mode
where the pitch of the incoming signal where the pitch of the incoming signal
is detected and displayed automati is detected and displayed automati
cally and a manual mode where you
set the target and tune to it
ress the MENU key until the display
shows and then press
TUNER,
On-key
�
Flat
hen you enter the tuner mode any
eff ect is automatically turned off 
f the tuner is in automatic mode
shown as on the display just play a
AT
note on your guitar  e tuner guesses
the closest note and shows it on the
display une the string roughly so that
the right note appears and then adjust
the tuning until the display shows a
large center blob
f the tuner is in manual mode shown
as on the display use the
MT
keys to set the note on the display and
14
— TASCAM CD-GT1
then tune as above
Calibrating the tuner.
sually the  above iddle  is tuned
to  z in most estern music
 ere may be times when you need to
tune to a diff erent standard you are
playing with another instrument or to

ENTER
a  which does not use the  z
� tuning se the tuners
Sharp
menu to set the reference  to a tun
ing between  z and  z
NOTE
Although you do not need to play a CD
when you are tuning, the CD-GT1 must be
switched on, and the
be pressed in to allow tuning of the guitar
plugged into the CD-GT1.
and
5 b
calibration
CAL
GUITAR
button must