Advanced Operation - Sony VID-P110 Bedienungsanleitung

To output the video signal from the VID-P110
camera and the audio signal from the
microphone connected to the MIC connector
Press the CAMERA button. The video signal from the
camera of the VID-P110 and the audio signal from the
microphone connected to the MIC connector are
automatically output.
When turned on, the video signal from the camera is
automatically output.
To output a signal from the video equipment
connected to the VID-P110
Press the VIDEO 1 or VIDEO 2 button.
The VIDEO IN connectors on the rear panel are
interlocked to the VIDEO buttons, the VIDEO IN 1
connector to the VIDEO 1 button and the VIDEO IN 2
connector to the VIDEO 2 button.
When the microphone is connected, this unit outputs
sound by mixing the audio signal from the AUDIO IN
connectors with the audio signal from the microphone.
When you want to switch the video signal from the
input connectors to the camera, press the CAMERA
button.
Note
When you connect video equipment to both the S
VIDEO IN 1 connector and the VIDEO IN 1 connector
on the rear panel, the video signal from the S VIDEO
IN 1 connector is automatically output. It is the same
when you connect both the VIDEO IN 2 and S VIDEO
IN 2 connectors.
Adjusting the microphone level
(VOL control)
Use the VOL control on the front of the VID-P110 to
adjust the level of the microphone connected to the
MIC connector. Turn it to the right to increase the
volume. Turn it to the left to decrease the volume.
Adjusting the image to your taste
The VID-P110 automatically adjusts the focus, iris and
white balance when you turn on the power and set the
material to be displayed in the middle of the screen.
You can also adjust them yourself manually as you
wish.
Presetting the pattern memory
(PATTERN MEMORY buttons)
The PATTERN MEMORY buttons on the operation
panel allow you to preset two pattern settings. The
pattern memory function memorizes the zoom, focus,
iris, white balance, lighting and effect (black & white,
negative) settings. Once you have preset the pattern
memory for an object you use often, you can recall the
pattern memory by pressing the button you preset.
1
2
3
MIC
VOL control
Microphone

Advanced Operation

Adjust the zoom, focus, iris, white balance,
lighting and effect (black & white, negative)
settings.
Press the PATTERN MEMORY SET button.
Press the PATTERN MEMORY 1 or 2 button
while the PATTERN MEMORY SET indicator is
flashing fast (for about 5 seconds).
The PATTERN MEMORY SET indicator lights
for about 2 seconds and then turns off. If the
PATTERN MEMORY SET indicator does not
light for about 2 seconds, the setting may not have
been memorized. In this case, repeat steps 1 to 3.
PATTERN MEMORY
SET 1 2
15