Braun Multiquick FP 1000 Bedienungsanleitung Seite 8

• The blades are very sharp!
• Before operating the food preparation
attachment, make sure that the lid
interlock (2c) is properly clicked in and
that the pusher (1) is in place.
• Do not insert other tools than the
pusher (1) into the filling tube during
processing.
• Always switch off the appliance before
removing the lid (2).
• The lid (2) can be cleaned under
running water, but do not immerse it in
water, nor clean it in a dishwasher.
• The bowl (4) is not microwave-proof.
Description
1 Pusher
2 Lid
2a Coupling for motor part
2b Filling tube
2c Lid interlock
3 Blade
4 Bowl
5 Anti-slip base (also serves as a lid)
6 Tool holder
6a Slicing tool
6b Shredding tool
Using the food preparation
(FP) attachment
Chopping
(see picture section
i
processing table )
The blade (3) is perfectly suited for
chopping meat, cheese, onions, herbs,
garlic, carrots, walnuts, hazelnuts,
almonds etc. For chopping hard goods,
use the turbo speed setting.
N.B.: Do not chop extremely hard food,
such as nutmeg, coffee beans and
grains.
Before chopping ...
– pre-cut meat, cheese, onions, garlic,
carrots, chillies
– remove stalks from herbs, un-shell nuts
– remove bones, tendons and gristle
from meat
For best results, please refer to the speed
settings recommended in the processing
table.
a) Carefully remove the plastic cover
from the blade (3). Caution: the blade
is very sharp! Always hold it by the
upper plastic part. Place the blade on
8
the centre pin of the bowl (4) and give
it a turn to lock into place. Always
place the bowl on the anti-slip base
(5).
b) Place the food in the chopper bowl.
c) Attach the lid (2) onto the bowl with
the interlock (2c) positioned next to
the bowl handle. To lock the lid, turn
it clockwise so that the interlock
engages with a «click» above the
handle.
d) To attach the motor part, first slide up
the cover of the opening for the FP
attachment. When attaching the motor
part to the coupling (2a), make sure
that the marking on the lid aligns with
the marking on the motor part. Then
turn the motor part 90° clockwise, until
it locks. Make sure the pusher is in
place.
e) To operate, press and hold the on/off
switch on the motor part and take hold
of the bowl with your other hand.
f) After use, turn the appliance off by
releasing the on/off switch and unplug
it, before you start disassembling.
To remove the motor part, hold the
FP attachment with one hand, turn the
motor part 90° anti-clockwise and lift
it off. Remove the pusher.
g) Pressing the lid interlock (2c), turn the
lid (2) counter-clockwise to unlatch it
and lift it up.
h) Carefully take out the blade by turning
A
with
and pulling it, before removing the
processed food.
Mixing light dough
Using the blade (3), you may also mix
light dough like a pancake batter or a
cake mixture based on up to 250 g flour.
For a pancake batter, for instance, first
pour liquids into the bowl, then add flour
and finally eggs. Using the turbo speed
setting, press and hold the on/off switch
to mix the batter until smooth.
Slicing / shredding
section
Using the slicing tool (6a), you can slice
e.g. cucumbers, onions, mushrooms,
apples, carrots, radishes, raw potatoes,
courgettes, cabbage. Using the
shredding tool (6b), you can shred e.g.
apples, carrots, raw potatoes, beetroot,
cabbage, cheese (soft to medium).
(see picture
B
with processing table
i
)