Taurus POLO 3000 Bedienungsanleitung Seite 14

- Use the appliance only for dry
working tasks.
- Never leave the appliance
connected and unattended if is
not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance on any
part of the body of a person or
animal.
Service:
- WARNING: There is a risk of
fire if the appliance is not clea-
ned following these instructions.
- Any misuse or failure to fo-
llow the instructions for use
renders the guarantee and the
manufacturer's liability null and
void.
Instructions for use
Before use:
- Remove the appliance's protective film.
- Make sure that all the product's packaging has been
removed.
- Prepare the appliance according to the function you
wish to use.
Vacuuming function:
- Fit the hose unit to the vacuum cleaner's air intake.
- To disconnect the hose unit from the vacuum cleaner,
press the two buttons on the hose joint at the same time
and pull outwards (Fig. 1)
Insertion of accessories into the appliance's grip:
- The appliance's grip is designed in such a way that it
allows the insertion of the following accessories (use the
combination that best meets your requirements)
- Extendable extension tube: Designed to provide access
to surfaces which are out of reach and make floor
cleaning comfortable, its length can be adjusted by using
the adjustment control.
- Lid: Specially designed for cleaning floors (both rugs,
carpets and hard floors), its base has a retractable brush
that can be adjusted to two heights for greater efficiency
on these floors.
- Lance: Specially designed for getting into cracks and
difficult corners.
Manual Polo 2000.indb 14
Use:
- Take the length of cable required out of the housing.
- Connect the appliance to the mains.
- Turn the appliance on using the on/off switch.
- Select the desired speed.
Electronic power control:
- The power of the appliance can be regulated by using
the power regulator control (G). This function is very
useful, as it makes it possible to adapt the power of the
appliance to the type of work that needs to be done.
Once you have finished using the appliance:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance to the mains.
- Retract the cable by pressing the roller cable button
and guide the cable into the appliance.
- Clean the appliance
Cord housing
This appliance has a cable compartment situated on its
posterior.
Carry handle/s:
- The device has a handle on the upper part so it can be
transported easily and comfortably.
Parking position:
- This appliance has one parking position for comfortable
and straightforward storage.
- To use the horizontal parking position, fix the break
pad hook to the hook situated on the rear side of the
appliance (Fig. 2)
Safety thermal protector:
- The appliance has a safety device, which protects the
appliance from overheating.
- If the appliance turns itself off and does not switch
itself on again, disconnect it from the mains supply, and
wait for approximately 45 minutes before reconnecting.
If the machine does not start again seek authorised tech-
nical assistance.
Cleaning
- Disconnect the appliance from the mains and let it cool
before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a few
drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or base
pH such as bleach, or abrasive products, for cleaning the
appliance.
- Do not submerge the appliance in water or any other
liquid, or place it under a running tap.
Changing the dust bag:
- Change the dust bag when there is a noticeable reduc-
tion in the suction power of the appliance. (The dust bag
does not necessarily have to be full to need changing;
for example, if very fine dust has been vacuumed this
can cover the pores in the bag and make it necessary to
28/11/12 12:05