Basic Operation; Turning On And Off The Tv; First Time Setup - Changchong LED32E4500T2 Bedienungsanleitung

Basic Operation

• Turn on the TV
Connect the TV to your mains socket.
If TV has a power switch, turn it on firstly. In standby mode, press
the remote to turn on the TV.
• Turn off the TV
Press the button on the remote control to enter standby mode.
Do not leave your TV in standby mode for long periods of time. It is best to unplug the
power cord.
NOTE:
 If there is an accident power off, the TV will be in standby mode automatically after
re-supply the power. To ensure the normal use of the TV, the frequent turning on and
off is forbidden, when there is an accident power off, it is recommended to unplug the
power cable from the power socket.
If this is the first time you run the TV, the Initial Setup Menu will appear in the picture,
and the items of this menu also exist in other menus, so you are able to change the
values after you set them up.
Tips: Make sure that the antenna connection is made.
■
Set you desired language
Press ▲/▼buttons to select the language to be used for menus and message.
■
Select your country
Press the ▲/▼ buttons to select the country you are living in, and then press the
►
button.
■
Select your time zone.
Press the ▲/▼ buttons to select a time zone, and then press the
■
Select your TV environment.
Press the ▲/▼ buttons to select the Home Mode or Store Mode and then press the
►
button.
• Home is the recommended setting to produce the best energy efficiency. If you want
to set Store Mode, a message appears asking you to confirm your choice.
■
Select the antenna type (Air
Press the ▲/▼ buttons to select the tuning modes and then press the
(For more detailed information, please refer to Channel menu → Auto
■
Auto Tuning
►
Press the button to start the auto searching.
First tuning DTV, press Menu and left arrow button to skip DTV tuning,
Second tuning ATV, press Menu and left arrow button to skip ATV tuning.
NOTE:
• If the TV doesn't receive any channels, please check your aerial connection or the
country you selected, and then try an auto search again.
• If the TV just receives some of the channels, it means the aerial's reception isn't good
enough and an antenna service is recommended.

Turning on and off the TV

First Time Setup

Cable ).
and
12
Power button on
►
button.
►
button.
Tuning).