Product Specifications; Power Supply - Optika EDUCAM MULTIMEDIA Bedienungsanleitung

Product specifications

Sensor
Horizontal resolution
Total resolution
Objective
Sensitivity
Picture controls
Gain control
White balance
Video signal
Working distance
Magnifications
Microphone
Audio signal

Power supply

Switching on
Length of flexible arm
Base diameter
Weight
Assembly
Power supply
The Educam Multimedia video camera requires 15 V DC working voltage and comes with an external power
pack. This power pack needs to be plugged directly into a 220 V mains sockets and its output cable should then
be plugged directly into the video camera power supply socket.
Video and audio signals
The analog video signal from the Educam video camera is transmitted to a TV monitor and the audio signal to
an amplifier or an amplified monitor. The small video/audio output signal cable, that can be found on the back of
the camera base, should be connected as follows:
Red plug (video signal):
into the video input of your monitor/colour TV directly or via the SCART adapter provided (in the yellow video
socket).
Black plug (audio signal):
into the audio input of your amplifier system or into the audio input of your monitor/colour TV or via the SCART
adapter provided (in the white audio mono socket).
Using the SCART adapter, it has to be inserted into the SCART socket at the back of the TV set. See the TV
manufacturer's instruction manual for details of how to switch on the TV and use its SCART circuit.
1/3" interline transfer colour CCD element
420 TV lines
244 k pixel
8 mm, F:1.2
min. 0,08 lux at F:1.2
electronic shutter
automatic
automatic
PAL compatible - VHS
from 0,76 mm to infinite
90x at 0,76 mm (with 21" monitor)
built-in high sensivity microphone
analogic
15 V DC, 400 mA, with external power adapter
via 3-position switch
50cm (Multimedia model), 65cm (Multimedia Pro model)
17 cm
3.4 Kg
Page 4