Bell SCA-2MR Bedienungshinweise Seite 18

If in [Command Mode , Page 5] „Keycode" has been activated, the displays will show:
Quit Standby Mode by eliminating the problem (for example short circuit at output) or by
A
entering the correct keycode.
Now the window to deactivate „Power Control" and „Sine TEST" will open.
If ‚Power Control' is deactivated in this new window, ‚Stand by Mode' will be inactive
B
after Mains off / on - even if the original problem (short circuit at speaker output) has not
been eliminated.
When „Sine Wave Test" is activated, „Power Control" should not be deactivated!
If in [Command Mode, Page 5] the „Keycode" function has not been activated, the LCD
Displays will show the information as under ‚B'.
4) Should the input level of CH.A or CH.B have a damping below 30dB,
[View Mode , Page 1] the „Auto Fade In" function will now be activated. This feature will
softly fade in the output level of the power amplifier in order to avoid any harsh or
unexpected loudspeaker signals.
5) In conjunction with the „Command" switch, the displays will now show the functions
of the „Command"- or „View" mode.
View Mode
This function is activated by pushing the „Command" switch (green LED off)
when View Mode has been activated. Select the next page by operating the page / exit
key.
Page 1
18