Berner Truck Pac Bedienungsanleitung Seite 69

Jump Starting Instructions
See details on next page for conditions that activate the AWS Detection Alarm.
1. Use in a well ventilated area.
2. Shield eyes. Always wear protective eyewear when working near batteries.
3. Prior to jump starting, review this entire instruction manual and the instruction/
safety manual provided by the manufacturer of the vehicle being jump started.
4. Turn vehicle ignition OFF before connecting jump starter to vehicle.
5. Confirm vehicle voltage.
6. Ensure that the jump starter's Voltage Selector Switch is in the
prior to connecting to the vehicle. Connect to vehicle.
7. With the jump starter's Selector Switch in the
(red +) clamp to the positive terminal on the vehicle battery (for negative ground
system), or an alternate vehicle starting point as recommended by vehicle
manufacturer.
8. Clamp the negative (black -) clamp to vehicle frame (ground).
9. Choose jump starter Voltage, by turning the Selector Switch to the desired
mode, to match vehicle voltage.
WARNING: Failure to properly match jump starter voltage and vehicle
voltage may result in explosion, product damage and bodily harm.
If AWS audible alarm sounds upon selecting jump starter Voltage, DISCONNECT
FROM VEHICLE IMMEDIATELY (remove negative clamp from vehicle ground).
10. Make sure the cables are not in the path of moving engine parts
(belts, fans, etc.)
11. Stay clear of batteries while jump starting.
12. Start the vehicle (turn on the vehicle ignition).
Note: If the vehicle doesn't start within 6 seconds, let the jump starter cool for
3 minutes before attempting to start the vehicle again or you may damage
the jump starter.
13. When the vehicle is started, disconnect from vehicle, first disconnecting the
negative (–) battery clamp from the vehicle frame and return it to its holster,
then disconnecting the positive (+) clamp and return it to it's holster. Then, turn
Voltage Selector Switch to the OFF position.
OFF
position, clamp the positive
68
OFF
position